HPE Comware Configuring Core Networking Technologies (H61M9) - Lab Topology

Lab Activity 1: Configuring IRF MAD

• Task 1: Establish an IRF topology
• Task 2: Establish distributed link aggregation
• Task 3: Configure BFD Multi-Active Detection
• Task 4: Test BFD Multi-active Detection
• Task 5: Restore your original configurations

Lab Activity 2: IP Routing with Multi-Area OSPF
Lab 2.1: Implement Single-Area OSPF

• Task 1: Build the topology
• Task 1: Configure OSPF with one area
• Task 2: Explore and observe Multi-Area LSAs
• Task 3: ABR Route Summarization and Route Filtering (not-advertise)
• Task 4: Observe effects of route aggregation

Lab 2.2: Implement Multi-Area OSPF

• Task 1: Divide the OSPF system into multiple areas
• Task 2: Explore the multi-area OSPF AS
• Task 3: Configure aggregated area summaries
• Task 4: Prohibit advertisements of area 0 routes in other areas

Lab 2.3: Implement Multi-Area OSPF

• Task 1: Reconfigure routers to support new topology
• Task 2: Configure the ASBR
• Task 3: Add a redundant connection to the new site
• Task 4: Configure a redundant ASBR
• Task 5: Configure stub areas
• Task 6: Configure totally stub areas
• Task 7: Add a redundant ABR

Lab Activity 3: IP Routing Using BGP protocol
Lab 3.1: Configuring Topology and Establishing BGP Sessions

• Task 1: Build the topology
• Task 2: Configure a BGP session to ISP1 on the company router
• Task 3: Configure a BGP sessions on the ISP1 router
• Task 4: Configure BGP sessions between ISP1 and ISP2
• Task 5: Configure authenticated BGP sessions between local AS and ISP2

Lab 3.2: Advertise and Receive Routes Using eBGP

• Task 1: Explore the BGP routing
• Task 2: Inject a network into BGP using a null route
• Task 3: Inject a network into BGP using a null route
• Task 4: Connect the company router to the OSPF AS
• Task 5: Advertise a default route in OSPF
• Task 6: Test the routing
• Task 7: Filter other ISP routes from BGP advertisements

Lab Activity 4: Configuring IGMP and PIM-Sparse Mode

• Task 1: Restore and verify the network topology
• Task 2: Prepare the multicast sender and receiver
• Task 3: Enable multicast routing and IGMP on receivers’ default gateway
• Task 4: Enable PIM-SM on routers between the source and receivers
• Task 5: Configure a static RP
• Task 6: Stream multicast traffic
• Task 7: Configure dynamic RPs

Lab Activity 5: Configuring Multi-VPN Instance Customer Edge (aka VRF-Lite)
Lab 5.1: Configuring Basic MCE (VRF Lite)

• Task 1: Restore devices to lab default settings
• Task 2: Configure backbone IP connectivity
• Task 3: Configure IP VPN services for Customer A
• Task 4: Configure OSPF dynamic routing inside IP VPN instance

Lab Activity 5.2: Configuring Advanced MCE (VRF Lite)

• Task 1: Configuring IP VPN instance routing limits
• Task 2: Configuring route leaking between VPN instances